Page 13-8
User Guide
What Is Happening
The receiver front panel
Power light is on, and there is
a picture on the TV screen,
but the picture:
• has sparkles or is grainy
• has a herringbone pattern
• lacks colour or vertical hold
• wobbles
• looks “washed out” or
fuzzy.
A “black box” fills almost all
of the TV screen.
The TV screen is all blue.
Possible Reason
• The TV set may not be working
properly.
• If the receiver is connected to
the remote TV using the RF or
VHF connections, there may be
a strong local broadcast on the
same channel, or a channel
adjacent to the one to which the
TV is tuned.
• There may be interference from
other nearby electrical devices
(such as radio towers, cellular
telephones, computers,
microwave ovens, radios,
stereos, or TVs).
• You may have turned on the
Closed Captioned feature on the
TV, and put that feature into
Text mode.
• You may have connected the
receiver to an input on the TV
that is incorrect for the signal
output from the receiver.
What to Do
• Make sure that the TV brightness and contrast
are adjusted correctly, and that the TV is
working properly.
• Make sure that the TV is connected properly to
the receiver.
• Check other nearby electrical devices as
possible sources of interference.
• Check that all required coaxial cables are in
place.
• Check for moisture or water leaking into all
connections. Dry them out if needed, then seal
them with coaxial cable sealant.
• Check the dish-to-receiver cable run length; if
it is over 100 feet, call your dealer or installer.
• Make sure the system is properly grounded.
• Using the TV remote control and/or menus
displayed by the TV (not the receiver remote
control or the menus displayed by the receiver),
turn off the closed captioned feature.
• Check your TV owner’s manual for the correct
TV input to use for the signal output from the
receiver.
TIMERS
What Is Happening
You try to set up an event
timer and the receiver
displays a message noting
that the program is locked.
You try to set up an event
timer and the receiver
displays a message noting
that the program is a Pay-Per-
View event.
You try to set up an event
timer, but the receiver
displays an Error message
giving you the option to
delete an event timer that was
set up earlier.
Possible Reason
• You must enter the password
before you can create an event
timer for a locked program.
• You must order a Pay-Per- View
event before you can create an
event timer for it.
• You already have set up the
maximum number of event
timers.
What to Do
• To be able to set up an event timer for the
program, first enter the password.
• To be able to set up an event timer for the
event, first order it.
• To be able to set up a new event timer, delete
one of the event timers you set up earlier.
(23 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales