User Guide
Message Number
093
Possible Reason
You may have set up the receiver
to reset itself back to the “factory
defaults,” that is, the settings it
had when it was shipped from
the factory.
What to Do
If you want to reset the receiver to its factory
default settings, select the Yes option. If not,
select the No option.
REMOTE CONTROL
What Is Happening
You cannot find the
remote control.
When you press a button on
the remote control, the
receiver does not do what
you expect.
Your UHF Pro remote control
does not work well from far
away.
When you press the remote
control Power button to turn
the receiver ON, the receiver
front panel Power light does
not light up.
Possible Reason
• N/A
• The remote control may be
missing batteries, the batteries
may be incorrectly placed in the
remote, or the batteries may be
weak or dead.
• You may be using the wrong
remote control (1 or 2) for the
menus (TV1 or TV2) you are
trying to operate.
• You may be experiencing
interference from objects near
your receiver antenna.
• Other lights are too bright.
• Remote control is not operating
properly or the batteries are
weak or dead.
• The receiver power cord is not
plugged into a power outlet, or
there may be a problem with the
power.
• The remote control(s) may not
be set to the address(es) used by
the satellite receiver.
• You may be using the wrong
remote control (1 or 2) for the
menus (TV1 or TV2) you are
trying to operate.
• If the receiver is in Single Mode,
the TV2 indicator will not light.
What to Do
• Use the receiver front panel Control Buttons to
control the receiver until you find the remote.
If the remote control is permanently lost or too
damaged to use, call the Customer Service
Center to order a replacement.
• If the batteries are missing or dead, insert fresh
AAA-size batteries. If the remote has fresh
batteries, check whether they are placed
according to the label diagram. If not, remove
them and place correctly.
• Make sure you are using Remote Control 1 (2)
to control TV1 (TV2) menus.
• Make sure the UHF antenna is connected to the
receiver and not touching anything else.
• Vary the tilt angle of the receiver's UHF
antenna. Locate the UHF antenna tip away
from other electronics equipment or metal
surfaces, even if separated by wooden shelving.
• Move the receiver to different locations. For
best results, place the receiver as high as
possible, above all other equipment in your
entertainment center.
• Place the UHF antenna outside the
entertainment center by using a coaxial cable to
connect it to the receiver.
• Try other remote control buttons to see if the
receiver is responding.
• Replace the remote batteries with fresh ones.
• Check that the receiver power cord is not
damaged, and that the plug is inserted correctly
into the outlet.
• Make sure the remote control(s) are set to the
same address(es) used by the satellite receiver.
See page page 10-2 for information on
changing the remote control address.
• Make sure you are using Remote Control 1 (2)
to control TV1 (TV2) menus.
• This is normal. No action required or switch to
Dual Mode.
Page 13-6
(23 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales